Post Office return is not available for items over 1.5m in length or 4kg in weight. For these items I ran out of builders sand half way through and used fine sharp sand instead, didn't make huge difference, well gauging water content made a much bigger bigger difference.

Loads of mixes on t'internet, I simply chose 1 cement (snowcem), 1 lime, 5 builders sand, cap full of PVA per mix. I could have coloured the mix but I was painting it and it is easier with some colour difference. The snowcem with lime comes off-white anyway. This manual Tyrolean gun has been designed to apply textured plaster or render to internal or external surfaces.<br />

Why buy from Toys4Vans

Scottish Islands: HS1-9, IV40-51, IV55-56, KA27-28, KW15-17, PA20, PA41-49, PA60-78, PH42-44, ZE1-3

Most of the house is original tyrolean from the 30s, so it has that rounded dimpled effect (easier to paint). Next door's extension used compressed air applied Cullamix which appears to give a very open textured almost granular effect, (would be a **** to paint).

International Deliveries including the Irish Republic & Channel Islands

following the guidance below, you can help us to help you when a product is not what you expected, or is faulty. Mask everything you don't want covering, it drips from the bottom of the tyrolean gun, especially when pointing down.. To get it consistant across the whole wall, start at the top with a plank to stand on running the full width, Hopefully, you won't need to return an item, however, if you do, it is our aim to make this as simple as possible. By

This is intended to be painted to match the rest of the house I went with the old mix and a hand cranked gun. Scottish Highlands: AB36-38, AB55-56, FK17-21, IV1-39, IV52-54, IV63, KW1-14, PA21-40, PH19-26, PH30-41, PH49-50This manual Tyrol machine is perfect for decorating and is designed to apply textured coatings to interior and exterior walls. Ideal for applying Tyrolean and roughcast wall covering on both exterior and interior walls. The adjustable pressure bar allows you to control the texture produced. The casing is made from a toughened one piece plastic construction. Start splattering until it fully covers the render and starts to drip/droop then move along, don't empty the gun as the last bit has less sand and changes the effect.

Some items are shipped directly by the manufacturer. In this case, the courier depends on manufacturer’s selection. Please see the below table for specialist direct from supplier delivery services.