Both have sand binder in them and work in similar ways however EASYSeal BCS is the superior product and lasts longer. For expert information on how to use brush-in grout make sure to visit our dedicated Help and Advice section.

Lastly is contains linseed oil, a vital ingredient to create a strong bond in the paving joint however to avoid this oil penetrating the paving stone the EASY Joint instructions inform you to thoroughly soak the paving, this keeps the linseed oil 'floating' on the surface of the water, rather than penetrating the stone.As the name implies, EASYJoint is easy to use – simply soak the paving with water before commencing and then simultaneously sweep and wash the jointing compound into the joints, letting the water take the strain.

Our instructions state that any sagging of a joint must be topped up whilst it is still wet (or has not cured). The landscaper applied the product without water and said this is the best way as the product is activated by the air and not water. Please note that drivers will unload materials to the side of the lorry but are not authorised to carry goods any further.Secondly, the water helps the compound flow in to the joint cavities and helps with compaction for a fuller joint without voids. The end results will be a perfect joint that is fully filled without need for kneeling and compressing the material by hand that will last for years and years. EASY Joint will always go rock hard as soon as it is in contact with the air, it does not need water to cure. Due to the structural requirements of a driveway and that generally, the bedding mix is stronger than that of a patio or path, the use of EASY Joint is not recommended.

A 6:1 bedding mix (six parts sharp sand to one part cement) when laying the paving is ideal in that it provides enough porosity in the mix for water to escape and the product to cure.

Azpects EASYJoint is the original sweep-in jointing Compound and still the best truly "All Weather Paving Joint Compound" available and made in the UK. It is suitable for all types of paving material provided there is a gap of at least 3mm wide and 25mm deep. Heavy Traffic Pro Jointing Mortar - 2-Part Epoxy Resin Mortar System - suitable for vehicle areas up to 7.

If using the wet method, ensure that the bedding mix is permeable and made up from a mix no stronger of 6 parts sharp sand to one cement. The best solution would be to get it laid as recommended by the suppliers and to then protect it by sealing it with one of our specialised EASYSealers, either EASYSeal BCS or EASYSeal Contract. Do not be tempted to use brick acid on paving, it will damage the paving and possibly the paving joint. The quick, hassle-free installation makes this one of the most efficient jointing methods available today so make sure you get yours now and experience a whole new level of fast and effective landscaping!Porcelain is impermeable (it will not allow water to pass through it) so follow our instructions for use with porcelain tiles. Finally, using water helps to lift the linseed oil in the compound off the paving as it is less dense than water - preventing any potential temporary staining. When you clean the patio hold the power washer at an angle of about 45⁰ degrees and using a fan spray from no closer than 150mm from the paving joint. Yes, you can clean our paving joints with a pressure washer but it must be done cautiously and after the EASY Joint sweep in sand has set hard.