20 Pieces Micro JST PH 2.0 2-Pin Connector Plug Male and 20 Pieces 10 cm Red and Black Silicone Cable Wire with Female Connector

Product Information

The term "JST" is sometimes incorrectly used as a vernacular term meaning any small white electrical connector mounted on PCBs. See the top left female connector in this photo from Common JST Connector Types - PH (2.0mm pitch): a b "List of JST connector series; JST". Archived from the original on 2020-11-12 . Retrieved 2013-08-31.

Among our electric components, we can put forward a wide variety of innovative catalog products and crimping tools: FFC/FPC connectors (insertion strength zero, no ZIF), to crimp/crossing, SMT/CMSThe fully shrouded header has walls on all four sides to prevent improper connection to the mating housing and to prevent the intrusion of flux and other contaminants. A female JST PH has one slot (or rather a cut-out) going down in the middle of the female. Which corresponds to the bar going down the middle of the male (as can be seen on your photo). Either side of the slot/cut-out are two small holes at the bottom. Choosing the Right JST Connector". DronesEtc. Archived from the original on 4 March 2016 . Retrieved 13 August 2015.

VH is a larger type of JST connector featuring positive latching and is generally used in high voltage and/or high current connections. Power supply connections in Japanese brand appliances is the most likely place to find them. The JST-PH connector is used on many high current micro ESC and LiPo batteries - e.g. the E-flite Blade mCPX helicopter, the Spektrum AR6400LBL receiver and several Parkzone, E-Flite 'UMX' models. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.

JST-SH | Molex Picoblade (1.25mm) | JST-ZH | Molex 2mm | JST-RCY | 1.27mm | AR6400/PKZ3352 | DC | Power For more obscure types, no hand tool is offered, however JST do sell a hand frame (YRS-XXX) for mounting dies for their MKS-L applicator (used in the AP-K2N crimping machine), a very expensive solution, and the only option for production/mission critical applications. Unofficial / Generic This connector is also available in a surface mount configuration. Its housing is made of heat resistant resin so that it is not adversely affected during reflow soldering. Because of its tiny size and ability to be surface mounted, this connector meets the demand for high-density mounting of components inside electronic products.

This is a thin, low-profile 2.0mm pitch connector 8.0mm in height after mounting and 4.5mm in width.

There's a good reference at mattmillan.com which helps to identify different types of JST connectors.

The WC-240 is nice to use, but there’s not a lot to set it apart from generic tools for occasional use. I personally crimp a large amount of PH, hence the investment in the official tool. The solder side of the header has a retention mechanism that prevents it from floating during soldering. As a result, the header can be positioned accurately. The female PH has a wide cut out and two holes at the bottom (2 mm pin spacing), whereas the XH has two slots from the top towards the bottom (2.5 mm pin spacing).

JST France, electronic components manufacturer, was established in Vitry-le-François in 1989. Our plant is composed of 3 machine shops (molding, assembly and stamping) and an industrialization