If two microphones are used on the same frequency at the same time then they will interfere with each other because the receiver cannot distinguish between different signals and cannot separate them out into separate signals. At first glance, the InnoGear Adjustable Microphone Stand looks as if it would topple easily, but that’s not the case whatsoever. The counterweight is so strong, and the heavy-duty base so sturdy, the stand can easily handle microphones weighing as much as 4.4 pounds. A: Yes, the TW-620 wireless microphone ' frequency range is 902.8-914MHz, it complies with the new FCC regulations. If you use multiple sets of TW-820 or TW-820 Plus receivers, because the frequency band of each microphone is different, it can be used normally without interfering with each other.

I hope you loved this Tonor T20 microphone boom arm review. Let me know if you have any questions. If you have this boom arm, don’t forget to rate it in the comment section below.The top knob doesn't tighten on my boom arm. So I cannot put my mic in a stand-up position. However this isn't really an issue for me since I planned on having it hang upside down and out of the way above my head. I'm sure this is just either a defective or not a factory perfect boom arm.

A: The mic of the TW-620 and TW-630 has 15 adjustable frequencies, so up to 15 systems can be used simultaneously and will not interfere with each other. If you are looking to create a polished and professional looking video podcast setup, this Mic stand will definitely take your video podcast to a new level!! It's very easy to put together as well! After about a year of use, I can say that the arm is really good, Ive been using it daily and haven't got too much problem with it. Definitely would recommend it, but make sure that you take one that is long enough, cause the smaller version is fine, but I needed to put it a bit far from me because of space issues, and it has started to bend a little bit, and I wish there was a way for us to screw the microphone a bit more, cause if u put a bit of force on the wrong way, the microphone just start to get unscrewed, which happens sometimes and can be annoying, but other than that definitely recommend it. Once your mic is working correctly, slowly add in (one-by-one) the antenna distribution, remote antennas, and other wireless systems until you have a complete working system. A:Yes, the frequency range of TONOR wireless microphones are complies with the new FCC regulations of 2020.Tonor T20 Microphone Boom Arm Review – Comparison with Other Cheap Boom Arms Tonor T20 Microphone boom arm vs i nnoGear Microphone Boom Arm